Ways of Use:
1.Open the engine cover, and hang the detector in the cover.
.Disconnect the pipe that needs to be connected with detector. If the pipe needs to be disconnected in the middle, please secure the other side with a rubber stopple.
3.Secure this side with proper taper stopple/pipe, and connect it with smoke output tube.
4.Connect detector with DC1V battery: red with positive, black with negative. Do not connect in a contrary way.
.Turn on the power switch, and detector starts to work.
6.In about 3 minutes, the pipe will be filled with smoke. Check the leak points. Please use head lamp if necessary.
.After leak detection, please connect well the wires and pipe.
. Please repair the leak part timely with specific tool.
Hook: To hang the detector when detecting
Working Indicator: It is lit when the detector works
Power Switch: Power it on, and the detector works
Smoke output tube: The smoke outlet which connecting with detection port
Power clip: To connect with vehicle battery. The voltage is DC1V.
Pressure gauge: To show the working pressure
1* Main Unit
1* Hook (with hand-tighten nuts)
1* Rubber stopples (with serial specification)
1* Taper stopple
1* Taper pipe
1* 30ml oil bottle
Customer reviews(0)Write Review